Ericsson LBI-38732D Manual de usuario descargar pdf (Pagina 10)

FOR BEST PERFORMANCE

1. Charge battery to full capacity, 14 hours at the stand-

ard C/10 rate (capacity X .10). For "rapid" chargers,

allow additional time (2-3 hours) for "topping off" the

charge after it switches from "fast" to "slow".

2. Use the battery soon and use as much of the battery

capacity as possible or practical. A battery that is

charged and discharged completely will maintain the

longest running time capacity. Also, several

charge/discharge cycles are recommended to bring

a new battery up to its rated capacity.

3. Store and charge the batteries at room temperature

65°F to 75°F. Batteries that have been stored for over

a month should be recharged before putting into

service due to chemical self-discharge which occurs

at a rate of approximately 1% per day. Do not charge

cold batteries (40°F or below).

4. Reduced capacity or "memory effect" may result

from repeated identical shallow discharge/full re-

charge cycles. If such a condition is suspected, run

the battery until the instrumentation loses all power,

then fully recharge and discharge again. Repeat this

cycle 3-4 times.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 107 108

Sin comentarios

Ericsson LBI-38732D Manual de usuario Pagina 10