Ericsson TT1222 Guía de usuario Pagina 190

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 198
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 189
Alarm Categories and Conditions
D.6 OAC Alarms
The OAC out alarm provides a controllable relay via an over-air (NCP) command.
This menu is only available if the Director V5 software option is enabled.
Table D.10: OAC Alarm Categories and Conditions
Alarm
Category
Contents
Alarm Description Remedy Default
OAC alarms:
Relay
Alarm
The OAC alarm relay
has been set using the
NCP command
DIR5_NCP2_SET_REL
AYS
This alarm is set
from the
‘headend’ via an
NCP command.
Any remedial
action should be
performed at the
headend.
A
D.7 IP Out Alarms
The IP out alarms provide alarm status for the IP outputs.
Note: These menus are only available when the Dual IP Output module is fitted in
the receiver.
The IP output card has two output Ethernet ports each supporting up to 4
independently configurable destination addresses. Table D.11 describes the alarms
and indicates if they are per port or per port and destination.
EN/LZT 790 0002/2 R1A
D-10
Vista de pagina 189

Comentarios a estos manuales

Sin comentarios