E/LZB 119 1890 R1A
12
Once service is available from an EDACS system, the
SERV (Service) indicator comes on, and the CC SCAN goes
off in the display.
Figure 6 - Service, Signal Strength and Battery Level
Indicators
• If the SERV indicator does not come on, you have
lost contact with the EDACS system and cannot,
therefore, place or receive any calls. Refer to
Operator’s Manual for further information.
PLACING AN INTERCONNECT CALL
(IPE-200)
1. Enter the desired number on the numeric keys. The
digits are shown in the display.
If you enter a wrong digit or a wrong number, erase a
wrong digit by pressing the
key momentarily. You
may delete all wrong digits individually like this, or
eliminate all entered digits by holding the
key for
approximately 1 second. If you are not in a call,
pressing the
key will also delete all entered digits.
2. When you have entered the number, press the
key.
The text "DIALING" shows in the display.
Figure 7 - DIALING and Phone Symbol Appears
When you have made contact with the EDACS system,
"DIALING" will disappear. The number dialed will remain
in the display until any key is pressed, or the call is ended, at
which time the minutes and seconds of the call will be
displayed. The left two digits show minutes, and the right
two digits show the seconds (separated by two dashes). The
air time of the outgoing call includes the time taken to
connect the call.
Figure 8 - Length Of Call Displayed
The air time meter is only a guide; actual time may differ.
3. When the conversation is finished, press .
If nobody answers or there is a busy or fast busy
tone, press
. The telephone number will be retained
in the memory and you can easily repeat the call.
Volume Control
During a conversation you can adjust the volume of the
earpiece with the Volume control
keys.
There are separate volume levels for hand held and
handsfree modes for both earpiece/speaker and the keypad
tones.
Mute Key
During a conversation, the microphone can be
deactivated by holding down the
key. Release the key
to resume the conversation.
LAST NUMBER RE-DIAL
1. Press , then to scroll to the RECALL function.
2. Then press
.
The word LAST DIAL will appear and the last dialed
number will be displayed.
3. Press
to place the call.
The last number called will remain in the memory even
though the radio is turned off.
NOTE
NOTE
NOTE
(22 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales