
E/LZB 119 1890 R1A
14
• Do not carry the radio by the antenna. Do not
use chemical cleaners, spray or petroleum based
products. They may damage the radio housing.
CAUTION
PERSONALITY PROGRAMMING
The EDACS-2 PC Programmer (TQ-3373) version
8.0
or later is used to edit, read or write the personality to the
IPE radio. A personality is simply a computer file generated
(created) by the user of the EDACS-2 program. The
computer file (or personality) is downloaded into the radio
and contains data that will direct certain operating
characteristics of the radio unit.
The EDACS-2 PC Programming software
communicates with the radio through the Troubleshoot Box
(item 1 in the equipment list). Figure provides a diagram of
the Equipment Setup required to PC Program the radio.
Refer to the PC Programming manual (TQ-3373) for
detailed software operating instruction.
Personality Programming Mode
The EDACS-2 PC Programmer cannot communicate
with the radio unless the radio is in the Programming Mode.
To place the IPE radio in Programming Mode:
1. Connect as shown in Figure 10 with all switches on
Troubleshoot Box (KRY 101 1612) in down or OFF
position.
2. Remove battery from IPE before programming.
3. Set
MASTER
switch to ON position.
4. Turn on radio by pressing
key.
5. After self-test of radio press
key.
6. Press the
key until PERS PROG appears in the
display.
7. Press
again and observe that display reads SURE?.
Figure 10 - Personality Programming Equipment Setup
ERICSSONUJ
KRY1011612
DB-9
Serial
Port
DB-15
Test
Port
ON
OFF
MASTER PHONE
SERVICE AF PATH
HOOK DIGITAL
MODE
AF IN
AF OUT
Test
Handset
12V
5V
OFF
BNC
HANDSET
ON
OFF
MODE 1
MODE 2
ON
Power Input
+15 VOLTS
Rear View Of
Computer
DB-9(M) to DB-9(F) Cable
KRY 101 1612/53
Test Cable
KRY 101 1612/52
Alexander 4
Connector
KRY 101 1062
Typical IPE-200 Radio
15 Volt
Wall Supply
KRY 101 1612/54
Comentarios a estos manuales