Ericsson G36 Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 31
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
Communications systems built to drive business ahead
MD Evolution 8.1
Product News
15
PN 06:16 Rev A 2006-10-20
Created by ESF/KEP/MA Francois Vaillant
CTA board provides 4 trunks with loop start support. Tone progress detection,
battery reversal detection, decadic (pulse) (66ms / 33ms) or DTMF dialing are
implemented on the CTA board.
Some other features are not available: tax pulse detection, system failure relay,
direct incoming dialing. But the available DISA service is an alternative to DID.
The CTA board interfaces are designed to meet FCC, TBR21, and some
specific country dependant standards (AC termination, DC characteristics, ring
detect and frequency, among others), and fulfill requirements for safety,
immunity, EMC according to EN55022 and EN55024, as well as FCC parts 15
and 68.
Protections against over voltage are included on the CTA boards. The CTA
interfaces can pass UL1950 tests, as well as ITU_T K21 basic level. In case of
strong environment, when it is required to fulfill K21 “enhanced level”,
additional external protections (gas discharge) must be provided.
The CTA consumption is 0.5 W. The MTBF estimate of the CTA board is
roughly 300000 hours.
Services available with the analogue trunks
Except the CLIP service on incoming calls, all other services are already
available with other external lines.
For incoming calls:
- Welcome messages
- CLIP service. Caller ID detection is handled in FSK
mode by four FSK modems located in the DSP on the
CPJ6 board. “On Hook Caller ID” reception (i.e.
during ringing phase) is implemented.
- DISA service
For outgoing calls:
- Toll restriction tables to enable/ disable external
local/international calls
- LCR service
- Call forwarding to external telephone number
- Hot-line extension calling an external telephone
number
For calls in progress:
- End-to-end dialing when calling an external device
asking for DTMF codes
- Flashing to get external services provided either by
the public exchange or by another PBX connected to
the MD Evolution system
- Trunk-to-trunk connection when you want transferring
an external call to another external call
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 30 31

Comentarios a estos manuales

Sin comentarios