Ericsson G36 Manual de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 31
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
Communications systems built to drive business ahead
MD Evolution 8.1
Product News
16
PN 06:16 Rev A 2006-10-20
Created by ESF/KEP/MA Francois Vaillant
Configuration of the analogue trunks
The parameters associated to the analogue trunk port TKA offer various
configurations:
- Any TKA is part of an a trunk group: up to 8 trunk group. All
personal TKA are part of the same trunk group.
- the TKA can support either general calls or dedicated to a
defined internal extension (individual or group number)
- the TKA can be dedicated to incoming calls or outgoing calls
or both types of way
- dialing can be either in DTMF or decadic mode (66ms/33ms)
- prefix to place outgoing calls programmable with 1 to 4 digits
- an incoming call on a personal TKA can be presented on the
associated extension that is temporarily in call forward status.
It can be programmed to enable/ disable call forwarding for
these calls coming from this personal TKA.
Other parameters are more technical:
- TKA can be defined as long/short line for voice quality
- Transmission time is defined for DTMF sending
- Routing table defines the format of the digit sequence (ie tone
detection, pause)
- More parameters required to define detection of the first and
second tones during dialing out
- Battery reversal, if available, defines when the voice path is
established and ended.
- When dialing out, one can defines the last digit (generally #) to
make voice connection
- Power break, specific to some country, available
- TA+1 dialing out procedure available for some country
- Flashing duration
Some characteristics are set by software, depending on the “Country
Parameter”. Among them: compression law, transmit/receive gains,
impedance, ringing detection threshold, DC current versus voltage curve
selection (FCC part 68 or TBR21).
Installation of the CTA Boards
The CTA boards do not require any special settings upon their commissioning.
Up to 8 CTA boards may be plugged into the connectors P1 to P7, as well as
into P8 (CAP connector) provided from the CPJ6 system basic board. CTA
boards do not require the software protection license "Expansion license"
associated to the "BOARD EXT." when plugged in the P3 to P8 connectors.
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

Comentarios a estos manuales

Sin comentarios