Ericsson RX8000 Series Especificaciones descargar pdf (Pagina 29)

Appendix

RX8200 Configuration Guide

5. For WNE, two multicast IP addresses exist to distinguish between PAL/625 and NTSC/525 on Reuters

WNE i.e., each broadcast stream exists on a separate multicast address. These addresses are provided

below:

Standard

IP Address

MAC Address

Hexadecimal

525

224.14.14.14

01:00:5E:0E:0E:0E

625

224.14.14.15

01:00:5E:0E:0E:0F

Figure 41 Multicast Addresses on WNE

6. Configure the transmission standard specific to your region as follows:

 Navigate to the Decode tab of the RX receiver browser page.

Figure 42 Configuring Multicast MAC Address and PID

 Within the MPE section, make sure the following information is included:

PID: From the drop down tab, the PID 3550 – USER should be available once the receiver is tuned

into RLS. If not, it will appear after the User PID has been selected and the changes applied to the

receivers configuration.

Filter MAC: Enter the MAC address as shown in Multicast Address graphic above for your region.

User PID: 3550

MPE Enable: Select this box.

Also ensure that the MPE Enable check box is enabled for IP Out Link 2.

 Click Apply Changes to store this configuration.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36 37

Sin comentarios

Ericsson RX8000 Series Especificaciones Pagina 29