Ericsson RX8000 Series Especificaciones descargar pdf (Pagina 9)

Receiver Configuration

RX8200 Configuration Guide

Configuring the RX8200

The most efficient way to configure an RX8200 is by using its web-based management interface. It is also possible

to configure most of the receiver functionality through the front panel menu control buttons which takes

considerably longer to complete.

3.2 USING THE RECEIVER FRONT PANEL MENU SYSTEM

 The four arrow pushbuttons are used to navigate through the receiver menu system. Each arrow pushbutton

backlight is illuminated when a further menu can be reached by pressing that pushbutton.

 The EDIT and SAVE pushbuttons are used to modify User Settings within the menu system. The EDIT

pushbutton backlight is illuminated when the current menu contains a User modifiable setting. To modify a User

Setting within a menu, press the EDIT pushbutton and then use the up and down pushbuttons to change the

User Setting. During this edit operation, both the EDIT and SAVE pushbutton backlights will be illuminated. If a

menu contains more than one modifiable User Setting, then the left and right pushbuttons are used to select

the User Setting that will be edited. When a User Setting has been modified, the SAVE pushbutton should be

pressed to confirm and action this new User Setting.

 Configure the IP addresses of this receiver for access to the Management and IP Data network interfaces.

Once the management IP address has been configured to the default Reuters address (172.16.2.20), the

remainder of this receiver configuration can be done through its Internet browser page.

3.3 DEFAULT IP ADDRESS – FRONT PANEL CONTROL

The default IP addresses for the Management control should be configured manually through the front panel menu. The

Management port called Control 2 (IP2) should be changed to a default IP address of 172.16.2.20. The Subnet address should

remain as 225.225.225.0.

Management Control 2 – Menu 1.1.3

Figure 8 Control 2 Network Address

3.4 CONFIGURATION OF RX8200 ON RLS – FRONT PANEL CONTROL

If you wish to simplify the configuration process, skip to Section 3.7 for instructions on configuration through a web

interface. The steps below are for manually configuring RLS only and do not set all WNE configuration paramaters.

 Go to Menu 3.2 and select RF INPUT 1. The Receiver can take its signals from four sources. Set-up source 1.

 Scroll to Menu 3.2.2.1. Enter the LNB FREQUENCY then press SAVE. This sets up the LNB frequency for the

selected Source in MHz.

 Scroll to Menu 3.2.2.2. Enter the SATELLITE FREQUENCY then press SAVE. This sets up the Satellite

frequency for the selected Source in MHz.

 Scroll to Menu 3.2.2.3. Enter the SYMBOL RATE then press SAVE. Sets the symbol rate for the selected

Source in Msymbol/s.

 Scroll to Menu 3.2.2.4. Enter the DVB Modulation Standard then press SAVE. This sets up the DVB

modulation Standard (DVB-S or DVB-S2). FEC detection is automatic. Currently, this is DVB-S for RLS.

 Scroll to Menu 3.2.2.7. Enter the SEARCH RANGE then press SAVE. This sets up the centre frequency

Search Range for the selected Source in kHz. Set this value to 5000kHz.

 Scroll to Menu 3.2.2.10. Enter the LNB POWER as either On or Off and then press SAVE.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

Sin comentarios

Ericsson RX8000 Series Especificaciones Pagina 9