Ericsson EDACS Station GETC1e 19D901868G4 Manual de instalación descargar pdf (Pagina 17)

LBI-38988

3. Run the load1e.exe program. Follow the on screen

instructions and program the Turbo Board.

Additional programming instructions may be found

in SRN1062 and LBI-38822.

NOTE

When using Turbo Board 344A4414 Group 2 (or

later) software, re-programming the GETC Turbo

Board will not alter previously stored Personality

Data. When Personality Data is present,

"load1e.exe" clears and performs CRC functions

over the code portion of memory only.

PERSONALITY PROGRAMMING

Personality refers to the system configuration data

stored in the GETC's memory. The GETC's Personality

includes system configuration information such as channel

frequencies, call parameters, operating modes, and

identification information.

The Personality Programming process involves using

the TQ-3357 GETC Shelf PC Programmer which includes

the programming software to create the desired personality

and transfer the Personality data to the battery backed-up

RAM located on the Turbo Board.

We recommend using the TQ3357 version 4 software

when programming the GETC’s personality. Version 4 must

be used to enable any of the new features available in the

344A9607G4 software. The TQ-3357 version 4 also allows

you to upload the GETC’s Personality without changing the

DIP switch settings.

NOTE

It is not necessary to recreate the personality when

upgrading from Group 1 or Group 2 software to

Group 4. However, to activate new features, read

the existing personality and edit the personality as

required.

Programming a Personality Through J100

When using TQ-3357 version 3 (or earlier) you must

program the personality through J100.

1. One end of the serial programming cable (TQ-3360)

should be connected to the computer. The other end of

the serial cable connects to the GETC Shelf connector

J100, see Figure 5.

2. Set the GETC DIP switches S1, S2, and S3 for the

programming mode as shown in Figure 6. DIP switches

S1-S3 are located near the front of the GETC Shelf, see

Figure 4.

S3S2S1

L1 L2 L3 L4 L5 L6 L7

T1 T2

U18R1

U19

J49

J27

J10

J9 J8 J5

J19

TP107

Software Disk

TQ-3357 V3 or earlier

COM 1 or

J100

Harness 19C336863G2

TQ-3360

TQ3357

GETC Shelf 19D901868G3

Cable

U19

J49

TP107

Turbo Board Lightning GETC

COM 2

Dip Switches S1-S3

Switch S4

Figure 5 - System Hook-Up Using J100

NOTE NOTE

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Comentarios a estos manuales

Sin comentarios

Ericsson EDACS Station GETC1e 19D901868G4 Manual de instalación Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Arrancadores remotos Ericsson EDACS Station GETC1e 19D901868G4