Ericsson EDACS MDX Manual del operador descargar pdf (Pagina 12)

TX Power Settings

High Power Settings

1. The "Tx High Power Calibration" window should be on the screen.

If this window is not on the screen, then use the F1 Next or F2 Prev

keys to toggle to the correct window.

2. Press F4 Tx On to key the transmitter.

3. Measure the transmitter power output.

4. With the Low Frequency value highlighted, increment or decrement

the current value (Hex or Decimal) until the specified window for

power is reached. See Table 3.

5. Measure the total radio current. Current should be less than the high

power current specification given in the table. The tracking data for

each band segment will be updated with the displayed value upon

exiting the calibration application (pressing F10 to exit and F1 to

update tracking data).

6. Press the F4 Tx Off to unkey the transmitter.

7. Repeat this procedure for the remaining 5 frequencies.

LBI-38898

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Sin comentarios

Ericsson EDACS MDX Manual del operador Pagina 12