
Sending A Group Call
1. Turn on the radio and set the POWER ON-OFF/VOL-
UME knob to the desired volume level. Select the
desired system and group.
2. Press and hold the PTT button. The radio will display
the system and group names and perform the
necessary signalling required to obtain a communi-
cation channel.
3.
When the working channel is assigned, and
are displayed and a short mid-pitch tone sounds
(if programmed) indicating communication can be-
gin.
4. Hold the radio approximately three inches from the
mouth and speak in a normal voice into the micro-
phone (located upper-left of speaker grille).
5. Release the PTT button when the transmission is
complete and listen for a reply.
If two or more tones, or a high pitched tone is heard,
the system may be busy and the call request has been
placed in queue or the request has been denied for
some reason. Refer to the ALERT TONES section for
more details.
NOTE
36
Comentarios a estos manuales