
EQ8096 M-CMTS System Test Specification
Select the output card/Spigot/QAM you wish to enable the session on, e.g. in our
example we enable Input Card Port 2 which is routed to Output Card 1, Spigot 2,
Qam channel 1. The Remote session id is supplied by the Core engineer and
corresponds to the “depi-remote-id” set up in the core “controller Modular-cable” set
up.
Figure 10.5 DEPI Session Setup
Then select “Apply Changes”. The enabled session will be grayed out and cannot
now be changed until they are disabled, e.g.:
Figure 10.6 DEPI Session Enabled
2/1553-FGC 101 1019 Uen A
10-7
Comentarios a estos manuales