Ericsson 1553-FGC 101 1010 Uen A Guía de usuario descargar pdf (Pagina 35)

Installing the Equipment

2.6.2 Connecting the Unit

Once the unit has been installed in its intended operating position, it is ready to be

connected to the rest of the system equipment providing it too has been installed.

Do not move or install equipment whilst it is still attached to the mains supply.

Ensure ESD precautions are observed whilst interconnecting equipment.

2.6.3 Active Data Port

2.6.3.1

2.6.3.2

Introduction

The EQ8096 supports four redundant data input interfaces. As standard, the

EQ8096 offers electrical (RJ-45) copper ports. These are active as 4 independent

pairs (8 physical connections).

The 1000BaseT connections are auto-speed sensing. There are two LED’s carried

by the connector. The green LED indicates the channel status (Link level connection

active) and the amber LED indicates channel activity.

Each data port is assigned its own unique IP address and subnet mask. These are

given factory default values at the point of manufacture. The IP address is

modifiable by the operator (see the User Guide for details).

SFP Mini-GBIC Modules (Optional)

Warning!

Class I Led Product when fitted with a fiber optic adapter. Do not look into the

aperture. Looking into the aperture could cause discomfort to your eye.

The EQ8096 supports four pairs of Small Form-factor Pluggable (SFP) Gigabit

Interface Converter (GBIC) slots. These take the form of a cage in the unit into

which an SFP pluggable module (not supplied) can be fitted.

When the SFP GBIC bi directional ports are enabled, the application monitors the

line status and presence of each of the modules. If the primary GBIC port is active

then this is used for data reception. If any of the primary ports are inactive for more

than one second, and the secondary module is active, then the application switches

to using the secondary port. If the application is using the secondary port and the

primary port becomes active for more than five seconds then the application

switches back to using the primary port for data reception.

Note: A port being active is defined as having a valid line connection rather than

receiving valid data.

2.6.3.3 1000BaseT Data Connectors

The gigabit Ethernet connections are RJ-45 connectors and are auto-speed sensing

between 10, 100 and 1000 Mbps.

2/1553-FGC 101 1019 Uen A

2-13

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 195 196

Sin comentarios

Ericsson 1553-FGC 101 1010 Uen A Guía de usuario Pagina 35