Ericsson 1553-FGC 101 1010 Uen A Guía de usuario descargar pdf (Pagina 44)

Operating the EQ8096 Using the Web Browser

3.2.2 Changing the IP Address

If the user accidentally sets the local address incorrectly, the EQ8096 may not be

accessible via the browser. The IP address can be changed using the Front Panel

Keypad (see Table 2.6) or using the following procedure:

1. Open a terminal emulation application on the PC.

Note: The EQ8096 serial port communications defaults to 115200 bit/s, 8 bit data,

no parity, 1 stop bit.

2. Power cycle the EQ8096.

3. The terminal emulator will display a boot sequence that gives the current Control

port settings.

4. Using the terminal, the user should enter the local IP address allocated to the

unit using the command IPn xxx.xxx.xxx.xxx

(e.g. IP 172.17.124.3) and then press return.

5. If required, the user may enter the local IP subnet mask allocated to the unit

using the command IPMASKn xxx.xxx.xxx.xxx

(e.g. IPMASK 255.255.0.0) and then press return.

6. If required, the user may enter the local IP gateway mask allocated to the unit

using the command IPGATEWAY xxx.xxx.xxx.xxx

(e.g. IPGATEWAY 192.168.63.254) and then press return.

7. The new IP settings will become active immediately. ‘n’ is the control port index

(1 – 4) as outlined below:

a CA Main

b CA Redundant

c Control Main

d Control redundant

3.2.3 Opening the Web Browser

Once the EQ8096 IP address has been activated, the user can open a web browser

application and enter the following URL address: http://assigned IP address

(where assigned IP address is the address set by the user).

This gives access to the web pages described in this chapter.

Note: If connecting through a LAN ensure that the option to use proxy server is

switched off.

2/1553-FGC 101 1019 Uen A

3-6

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 195 196

Sin comentarios

Ericsson 1553-FGC 101 1010 Uen A Guía de usuario Pagina 44